Options      Specifications      Spindle Configurations

ULTRA      GSE-523

The GSE523 is ideally suited for the smaller cabinet and millwork shop.  Great for the smaller profiles, S4S, tongue and grove and other short run types of manufacturing.

Convenient Spindle Adjustment

  • All controls for the spindles are located at the front of the machine for convenient adjustment.  Each spindle is provided with mechanical digital readout, giving accurate adjustment.

 

 

Side Front Pressure Plate on Left Vertical Spindle

  • Fully eliminates unsmooth problems when feeding short or narrow stock.  The pressure plate is easy to adjust.

 

Convenient In-Feed Adjustment

  • Two levers located at the right side in-feed. Unlocking and movement are in the same location.

Over Height Protection

  • The in-feed  is equipped with an overhead flap.  Which will stop the feed if the material is over sized.

 


Front Chip Breaker and Rear Pressure Plate

  • The front pressure plate devices  have a retracting feature, which fully avoids damage on cutters caused by an over-height work piece.  The rear pressure plate provides extremely uniform accuracy making it parallel to the table surface.

 

 

Feed Magazine

  • Provides constant feeding with no gaps particularly with short stock.  Thus increasing the rate of production and also is a good safety feature particularly on very short pieces.

 

 

Adjustable Short Stock Pressure Roller

  • The pressure roller for short stock can be raised quickly providing maximum convenience while changing the fence side cutterhead.

Universal Spindle(Optional)

  • This spindle can be tilted for complicated cutting jobs.

 

Specifications

Working Width 10-230mm / 3/4-9"
Working Height 7-125mm / 3/8-5"
Number of Spindles 4-5
Motor Capacity per Spindle 10 HP
Motor Capacity of Feed 4 HP
Spindle Speed 6000 RPM
Spindle Diameter 40mm / 1 13/16"
Tool Cutting Circle, First Bottom Spindle 100-150mm
Tool Cutting Circle, Vertical Spindles, Left 100-180mm
Tool Cutting Circle, Vertical Spindles, Right 100-180mm
Tool Cutting Circle, Horizontal Spindles, top 100-180mm
Tool Cutting Circle, Horizontal Spindles, Bottom 100-200mm
Feed Motor 3 HP
Bottom Horizontal Spindle 10 HP
Right / Left Vertcical Spindle 10 HP
Top Horizontal Spindle 15 HP
2nd Bottom Horizontal Spindle 10 HP
Table Length 2000mm
Feed Speed 6-25 m/min / 20-76 f/min
Pneumatic Pressure for feed rollers 6 bar / 80 psi
Adjustment range for infeed table and edge-jointing fence 12mm
Mechanical digital readouts for the pressure shoes and hold-down unit
Full Sound and Safety Enclosure
Motorized vertical adjustment feed
Lateral pressure roller opposite first right spindle
Chainless cardan feed system

 

Spindle Configurations


Webmaster:  Tyler Dicks
Copyright 2001 Moulder Techniques. All rights reserved.
Revised: 06/27/13.